Hello AutoHex Forum.

I'm having a hard time connecting to any DME using TriCore Cable so I want to make sure pin outs are correct.

Pin 2) CAN Low 1
Pin 5) CKL 2
Pin 6) CAN Low 2
Pin 10) CAN High 1
Pin 11) CKL 1
Pin 12) CAN High 2
Pin 14) Signal 1
Pin 15) Signal 2
Pin 18) Boot
Pin 19) 12V
Pin 25) GND

Can someone please help me to make sure these are the correct layouts because I want to label these wires that way it will be easy to remember.

Please contact support team they will check if your cable is correct according to your Autohex hardware.

I have tried to reach to them multiple times but can never get a proper answer.

https://www.microtronik.com/autohexmembers  and provide us with the ticket number. We will then follow up with the team.

I have opened the support ticket and ticket number is 4446.

Please check your ticket and reply on the same ticket if you have further questions.