So, I have the FEM here. It communicates OK on the bench for Key Lerning (in in the slot 10 - YES), on bench FA Manager (can read FA). It will not communicate for on bench FEM/BDC Unlock and on bench CAS firmware.

In coding programming communicates fine. I updated it.

I can see the bench unlock is using the ethernet comms between FEM and DLC. Does the FEM disable the ethernet somehow? If so how to enable it?

Any ideas????

Thanks.

Please ensure that ENET (DoIP) is enabled in the settings; once checked, the onbench unlock should work properly. enet1.jpg You have insufficient rights to see the content.

Yes, of course enabled. It will not communicate on ENET with other tools. So, this is not and Autohex issue. I wanted to determine if there is any setting I can apply to enable (turn on) ethernet. Someone programmed an aftermarket key to this FEM previously. Maybe they messed something up.

..if someone messed up try flashing gateway and body via can of course then try unlock enet should wake up then