1. Microtronik Autohex II and Hexprog forum
  2. Autohex II BMW
  3. Autohex II Ecu Flashing/Coding
  4. ELV Problem after programming CAS
Merit
  •  Merit
  • 55% (Neutral)
  • Newbie Topic Starter
2017-09-29T21:50:04Z
Hi all


Yesterday i have programmed a CAS with autohex and after flash completed the yellow ELV fault appeared . The car has no ELV mounted on it .
The Question is Can i remove it by manual coding ?

Thank you
Sponsor

Start ECU Repairing, ECU Cloning, and Chip Tuning today, all from an incredible price of just USD 385.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page

Gbyleveldt
2017-09-30T04:28:09Z
Nope, can't fix with coding.

Which car is it? Either AH loaded the wrong flash on that CAS for the vehicle type (possible, but unlikely), or the car is supposed to have ELV, but someone removed it and loaded non ELV software on the CAS.
Autohex_II_BMW
2017-09-30T05:21:12Z
Is this CAS original for car or do you change something in FA.
Merit
  •  Merit
  • 55% (Neutral)
  • Newbie Topic Starter
2017-09-30T09:46:13Z
Yes the car supposed to have ELV and someone removed it . How Can i restore it ?
Gbyleveldt
2017-09-30T11:31:59Z
You'll have to be comfortable with WinKFP, check what the previous zusb was and load that.
Similar Topics
Users browsing this topic
  1. Microtronik Autohex II and Hexprog forum
  2. Autohex II BMW
  3. Autohex II Ecu Flashing/Coding
  4. ELV Problem after programming CAS