Two bugs today HW4 1.0.45:
1. Try coding disable start / stop F30, conenct > FEM > tsa_memory > active > start coding > wait wait, module is restart, but coding not change (esys work ok)
2. Add camera to X6 E71, add to FA - > ok work, coding pdc and navi > not work, not coding camera options, I must change manual values.

I have the same issue

I modify the coding on a module in a F10 series vehicle, save it
Reopen the coding and it hasn't been saved

I would also say this perhaps extends beyond autohex as esys fails on the same vehicle

Autohex online support had a go of coding

Their conclusion was it couldn't be coded i.e. its something not supported by the car

Yet others report it can be done

Make your own mind up on that I suppose

Please take note of different CAFD mapping in F and G series...BMW has a habit of changing mapping in each I-step version.

Two bugs today HW4 1.0.45:
1. Try coding disable start / stop F30, conenct > FEM > tsa_memory > active > start coding > wait wait, module is restart, but coding not change (esys work ok)
2. Add camera to X6 E71, add to FA - > ok work, coding pdc and navi > not work, not coding camera options, I must change manual values.

1. Go to dde/dme and disable msa from there. Works.