Hi everyone,
I have an issue with an f30 bmw, after reading isn and coding 2 aftermarket 434mhz keys, the car does not start. Remote works, ignition comes on, but I get a message saying ignition/starter fault. Starter is ok as I can power pin 1 on the fem and spin it over.

Could it be a key fault, even though they switch the car on? I heard aftermarket keys can be dodgy on 434mhz in particular.

Sorry if these are noob questions!

Thanks for your help!

use ISTA D or launch to renew starter interlock on CAS

It is a bdc? Can I still renew interlock?

http://www.microtronik.c...TA-D-for-Autohex-II-WVCI  )
From ISTA-D you can reset startup.

Inject cafd with e-sys, and car starts again. Or make coding with autohex

Thank you for your help, flashed the bdc, gateway and dme with autohex and now car works again.