EGS - ISN · Microtronik Autohex II and Hexprog forum

Welcome Guest! To enable all features please Login or Register.

ellia
55.2% (Neutral)
Newbie Topic Starter

2015-10-20T20:18:32Z

Hi..

I can't read ISN from EGS X6 VIN: LZ95254 - GSB233 (7643097),can you help me?

Sponsor

Start ECU Repairing, ECU Cloning, and Chip Tuning today, all from an incredible price of just USD 385.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page

Wanna join the discussion?! Login to your Microtronik Autohex II and Hexprog forum forum account or Register a new forum account

Autohex_II_BMW
100% (Exalted)
Advanced Member

2015-10-21T10:36:14Z

If this 8HP EGS, then it has SK (128 bits) not ISN.
Is it showing you the EGS status? like: EWS stored in EEPROM, EWS active...?
Or it shows a message like: EGS not supported?

ellia
55.2% (Neutral)
Newbie Topic Starter

2015-10-21T11:02:52Z

shows a message like: EGS not supported.. 😞

Autohex_II_BMW
100% (Exalted)
Advanced Member

2015-10-21T11:19:03Z

Can you please show a picture of the software message?

ellia
55.2% (Neutral)
Newbie Topic Starter

2015-10-21T11:34:47Z

I've changed DME ECU wrote in Cas DME from SK (128bit) I could start engine but gear selector wasn't working.can I do anything?

ellia
55.2% (Neutral)
Newbie Topic Starter

2015-10-21T11:37:50Z

I've called, the car will come and I'll get printscreens...

Autohex_II_BMW
100% (Exalted)
Advanced Member

2015-10-21T15:07:52Z

In DME ISN, please check ISN Mode.
If ISN mode is: Read/Write, then you are lucky today.
You return the ISN back to CAS (original ISN), then go to DME ISN, and Write this ISN into DME.
All will be ok.
I think if this DME is not MSD85, then it will be read/write.

Autohex_ISN_Read_Write.png You have insufficient rights to see the content.

Edited by user 2015-10-21T15:18:47Z | Reason: upload picture

ellia
55.2% (Neutral)
Newbie Topic Starter

2015-10-22T07:45:30Z

I tried that too but unfortunately DME is MSD85... 😞

EcuMaster
55.6% (Neutral)
Newbie

2015-10-22T10:15:43Z

continental dme is painful.
please inform me if you find a way to work with egs.

bmstation
56.6% (Neutral)
Newbie

2016-03-08T11:42:14Z

#10

I did a E70 few days ago, with used DME, worked out well.
You must go to service functions first, and do a EGS-EWS reset then you change the ISN in CAS..
Once it starts and drive
Go back to service functions then do EGS-EWS learning
Job done