Hi sorry but i have to disagree with your above answer
We replied you by email the steps of what to do,
You have not told me what to do, In a matter of fact you have gave me very limited information, I have asked the same question 3 times in 3 seperate email and you have not told me wether it is an option in your replys
you have told me that
CAS coding should not cause an issue like this.
( It has caused this issue ignition was turning on before and key was accepted until coding was done) DDE7 should have SK (128 bits ISN)
( Autohex is reading short ISN)You have told me to read ISN of DDE
- Read ISN of DDE
- Make a new key for the CAS using this ISN, if it has been accepted, then all will be good and car will start ( You will need a blank key and Htag Pro to do this function)
This cannot be done as when reading ISN from DDE7 i only get the Short ISN
Your last email and you havent replied to me since goes like
DDE7 should give u 16 bytes (32 digits) ISN
The CAS ISN is not correct. It shows something wrong in the EEPROM
Regards
Now correct me if i,m wrong but you havent told me how to correct this problem, You havent explained why the software has created this problem and also i have asked you in 3 seperate occasions can i use a another CAS unit with the same part number which in not crypted and has a working key and if so How, and you havent also answered that Question,
You have not replied to the last email and put the above reply on here as if the problem has been sorted when it has notThe followin 2 picture are the ISN numbers read
IMG_0139.JPG
You have insufficient rights to see the content. IMG_0140.JPG
You have insufficient rights to see the content. Many thanks for your time