Hi guys,
I did an F01 spare key but something wrong. I programmed lots of cas4 and cas4+ keys without any problem.
What I did:
- I removed the cas4 from the car, soldered the wires, read P and D flash with hextag without any problem.
- I put back the cas4 to the car, I made a key from the D-flash dump.
- I held the new key at the key icon until the new key programmed.
- remote working, car start, keyless works fine than usually.
- I tested it 3 times. start again, stop the car, remote test...etc. everything was perfect.
- after that I put back the plactic cover above the pedals, 3 screws, job done but.....
The windscreen wiper started itself. wtf?
I tried to start the car but no luck just crank a short time (1s).
The windscreen wiper always running itself.
I tried connect AH via obd but it show the battery voltage 0 (the battery is full and gysflash connected.) no communication. remote working on the new key and on the original key.
I checked the cas, no soldering issue, totally clean.
I connected the cas4 and the ZGW on bench. I can see the cas key data, and I can read fault codes from the cas and from the ZGW. So i think both modules works fine.
First time when I connected these modules on bench AH show me an error messages. '' WARNING: ZGW vehicle order data corrupted ''
but after that never show this message.
so now the car dead and I don't have idea what's wrong.
did I something wrong under the process? fuse? relay? wires?
Why started the car without any problem 3 times after key programming and after 10 min start the windscreen wiper itself and dead the car? I don't understand.
I read again the d and p flash and totally same than first time, not corrupt.
Can anyone help me about it?
zgw.png You have insufficient rights to see the content.
IMG_20200409_184717__01.jpg You have insufficient rights to see the content.
Dump.zip You have insufficient rights to see the content.