have here a damage F serie 2041 ecu with bosch number 0261S10428.
have get a other ecu with same number.
is it just get ISN from original ecu and put it in donor ecu and done?
or have to do some more actions after?

also do someone know what is inside? is this a MEVD17.2 or MEVD17.2G or ?????

update: try read ISN with autohex as MEVD17.2(G) and both keep getting "cant communicate with ecu" check wiring and try again.
just have update autohex also.

now autohex gonna update again from BMW_01 from microtronic till BME_25.
whats going on??????

have here a damage F serie 2041 ecu with bosch number 0261S10428.
have get a other ecu with same number.
is it just get ISN from original ecu and put it in donor ecu and done?
or have to do some more actions after?

also do someone know what is inside? is this a MEVD17.2 or MEVD17.2G or ?????

update: try read ISN with autohex as MEVD17.2(G) and both keep getting "cant communicate with ecu" check wiring and try again.
just have update autohex also.

now autohex gonna update again from BMW_01 from microtronic till BME_25.
whats going on??????

you need to read isn from original dme and write to donor dme then do programming for dme on car, if you are getting error in factory mode you can click on configuration page of software and try to read ISN, make sure your wiring is correct. You can contact support via skype/whatsapp. send your connection diagrams over there and we also recommend you to use 12V 2A power supply.

oke after confuguration page i could read the dme.
thank you for help

If trans is automatic it might not shift after changing ISN in CAS.

i have put the original ISN into a donor ecu.
after the client come back from vacation i gonna programm the donor ecu to the car.

If trans is automatic it might not shift after changing ISN in CAS.

sorry actually we meant donor DME by mistake wrote CAS.

Hi,
after mount donor ecu car start but can't shift in gera.
also have no throttle reaction.
anyone know if this is due to coding ecu ?

Hi,
after mount donor ecu car start but can't shift in gera.
also have no throttle reaction.
anyone know if this is due to coding ecu ?

if you have incorrect data record fault on donor dme throttle response will be low. then you have to reset working hours in factory mode. and program dme on car. also check fault codes as you have egs not working

Hi,
after mount donor ecu car start but can't shift in gera.
also have no throttle reaction.
anyone know if this is due to coding ecu ?

if you have incorrect data record fault on donor dme throttle response will be low. then you have to reset working hours in factory mode. and program dme on car. also check fault codes as you have egs not working

i had made Hour 0 in donor DME. but later on i gonna read the car for fault codes and program the DME to the car.
gonna get back with results.