miksonics
2021-02-09T09:40:14Z
hi does anyone have the bench wiring setup with jbe to do connection between cas and dme for ews alignment ob bench?
Sponsor

Start ECU Repairing, ECU Cloning, and Chip Tuning today, all from an incredible price of just USD 385.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page

CipiCip
2021-02-09T15:47:08Z
I dont think you need jbe for this
I think only cas and dde connected with bench cable from autohex HW4 CAS3&MSD85.png You have insufficient rights to see the content.
In this situation autohex is your jbe
roxetteer
2021-02-09T19:48:19Z
CipiCip is right...AH4 acts as a gateway for connection between CAS and DME.
Autohex_II_BMW
2021-02-10T08:41:13Z
for cars having short isn need to sync cas -dme on car . for doing that onbench you may need to connect cas dme as like in car on onbench with jbbe. for dme which have long isn no need to do sync other than match isn but for short isn dme should do cas-dme sync . autohex will do automatically from isn manager option if its on car. onbench may require the same kind of wiring as like on car so may require wiring with jbbe to sync cas-dme.
Tombo
2021-03-10T22:01:54Z
needs only d_ews line as extra.
Personally using jbe in benc set up but not essential