isn read from dme EDC17c50 · Microtronik Autohex II and Hexprog forum

Welcome Guest! To enable all features please Login or Register.

zain
97.6% (Exalted)
Advanced Member Topic Starter

2020-08-04T13:02:48Z

Hi
I have a F30 all keys lost I am trying to read isn from the dme EDC17c50
I can see the voltage on the system but when i try and read i get a message low power from autohex II 12V jack

Edited by moderator 2020-08-04T23:41:04Z | Reason: Not specified

Sponsor

Start Ecu Tuning today with Hexprog II Basic Set, all from an incredible price: ONLY USD 575.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page

Admin
100% (Exalted)
Administration

2020-08-04T22:35:08Z

This message may present in following cases
The connected power supply is not good enough ( low amp)
There is a short among the wires of tricore cable
Wring connection to the ECU
Faulty ECU ( internal short)

zain
97.6% (Exalted)
Advanced Member Topic Starter

2020-08-05T08:48:13Z

I am not getting voltage at the red wire with the big clip of the tricore connector

zain
97.6% (Exalted)
Advanced Member Topic Starter

2020-08-05T17:21:11Z

is it possible to buy another tricore cable this one does not seem to be working it is the first time I have used it
I managed to read it using magic flex and sent them the read they sent me the isn

Admin
100% (Exalted)
Administration

2020-08-05T20:51:42Z

Red wire will have 12v only when the tool processing the read/write operations
You should check voltage while it is trying to communicate

Autohex_II_BMW
100% (Exalted)
Advanced Member

2020-08-06T06:04:45Z

Originally Posted by: zain

is it possible to buy another tricore cable this one does not seem to be working it is the first time I have used it
I managed to read it using magic flex and sent them the read they sent me the isn

change your power supply and use normal 12V 2A AC/DC adapter it will work.

clinton348
54.4% (Neutral)
Newbie

2020-08-06T17:11:57Z

@ Amp adapter solved this problem for me.