http://www.microtronik.c...ader-and-writer-software 

i read about 8hp ISN
I change dme , read isn used dme, input isn in cas. Car work perfect but gear not hitching all ok . i read link:



If the car is equipped with an EGS 8HP which shares the same ISN (SK) in DME and CAS, it will be locked when you modify CAS ISN to be matched with DME/DDE (as a result EGS 8HP ISN differs from CAS ISN).


but have another information
In the case of DME is read only (MSD81, MSD85,...), there is a solution to modify BMW ISN in these modules via ISN Tricore boot mode using Autohex II tool.

how I can do this procedure.?if it only provides the read option?

You need to use ISN tricore boot mode software to do this job.
You can read ISN from old DME (or from CAS), then write this ISN in the donor DME.
This way all Ecus (CAS, DME, and EGS) have same ISN, so everything will work fine.

you have procedure?
need new interface our old interface work good?

Autohex II WVCI HW3 is required to work with BNW ISN boot mode.
Please read this:
http://www.microtronik.c...i-wvci-new-hardware-hw3/ 

OK i go order new interface, In software ISN BOOT MODE have MSD81, MSD85 ???because i not see . only information

please also conform that your DME is BOSCH or CONTINENTAL
As i read about MSD85 in the website they explained that Autohex ii is supporting
Also conform for boot mode because MSD85 is not mentioned in ISN boot mode driver

MSD80, MSD81, and MSD85 are supported by boot mode (Read and write ISN).
It is not shown in the list yet, next update you can see it.
If you need it urgently, request the modified software from technical support.

Ok very thx,i dont need urgent now need received fisrt WVCI HW3

thx for information

isn boot mode will support continental ecus or no?

Can't you read?

MSD80, MSD81, and MSD85 are supported by boot mode (Read and write ISN).
It is not shown in the list yet, next update you can see it.
If you need it urgently, request the modified software from technical support.

isn boot mode will support continental ecus or no?

Support in next update all in list isn boot mode

Yesterday BMW version 1.0.40 has been released.
http://www.microtronik.c...i-bmw-software-id-100027 
You can see these ecus in the program list.
Cheers

I'm going to pay my new interface on Monday, on the new models I know where to put the pin in the MSD80 now, I have not the slightest idea.

Eu acredito que este é um fórum de língua inglesa só mate .. 🙂

---