1. Microtronik Autohex II and Hexprog forum
  2. Autohex II BMW
  3. Autohex II DME/DDE and CAS ISN
  4. Getrag exchange
Hussein
  •  Hussein
  • 76.2% (Friendly)
  • Member Topic Starter
2022-07-23T21:49:25Z
Hello,
I would like to ask i have x1 f48 the tcu does not respond, if i get used one does it need to be reset?
Thanks in advance
Sponsor

Start ECU Repairing, ECU Cloning, and Chip Tuning today, all from an incredible price of just USD 385.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page

ANDRIKSSON
2022-07-24T18:22:35Z
I have same problem too.
Autohex_II_BMW
2022-07-25T07:35:18Z
These egs have isn so egs need to be cloned or reset, you can clone if the original tcu communicates. please contact the support team they will check tcu if supported to clone in hexprog.
Hussein
  •  Hussein
  • 76.2% (Friendly)
  • Member Topic Starter
2022-07-26T06:57:14Z
Unfortunately the original tcu can't communicate,is there a way to reset the EGS?
Thanks
Autohex_II_BMW
2022-07-26T07:16:43Z
AS this DCT tcus still not supported for reset , but only cloning. but as original tcu not communicating nothing can be done.
Tombo
2022-09-06T09:41:08Z
Can be done 100%

8 or 9 done already
https://www.facebook.com/BMPassions 
Hussein
  •  Hussein
  • 76.2% (Friendly)
  • Member Topic Starter
2022-09-06T10:20:10Z
Hello Tom,
How can it be done?how can i contact you?
Similar Topics
Users browsing this topic
  1. Microtronik Autohex II and Hexprog forum
  2. Autohex II BMW
  3. Autohex II DME/DDE and CAS ISN
  4. Getrag exchange