pungo1212
2022-09-12T00:40:22Z
Hi. So far I have used the Hextag to clone a couple of CAS modules but I don't use it too much because of the type of work I get. Now I have an E46 the the cluster is taking down the K-bus, so I want to install a used one. I can't find any microtronik videos that show how to do it. Can it be done without removing the chip? If I have to remove it, how do I connect to Hexprog? Thank you. I apologize but I haven;t used it very much and finding any instructions on this topic is not easy.Thank you for your help.
Sponsor

Want to repair your Ecu?

Visit Hexprog page

PDXAutoworks
2022-09-12T16:50:49Z
Disassemble the cluster and remove the 35080 eeprom chip. Use the provided eeprom adaptor and read the data from the chip. Edit the data, write back and solder the chip back on.
BMW File Service
VAG Immo Data Transfer
pungo1212
2022-09-14T02:23:28Z
What Hex edit program did you use for the VIN edit? I am trying to figure out the best way. I read it and changed miles, but I still need to do VIN. Thank you very much.
pungo1212
2022-09-14T02:46:39Z
OK. I used Hex Editor and was able to open my file. Now how can I tell which is the VIN and how can I change it to new vin?
Thank you again.
I was trying to attach the file here but it won't let me.
Autohex_II_BMW
2022-09-14T09:09:17Z
have to locate the vin from eeprom file and edit that manually, please check if eeprom vin is encrypted or not.
PDXAutoworks
2022-09-14T14:06:43Z
Put the file here and I can help you with the VIN.
BMW File Service
VAG Immo Data Transfer