kkxdrive
  •  kkxdrive
  • 63.2% (Friendly)
  • Member Topic Starter
2017-01-29T10:58:30Z
Hi. New to autohex. Tryed to code e90 frm module. Changed some settings from active to not etc which went all ok...but, every time i read (encode) frm ecu, all settings goes to standard (basic) and i need to do it all over again. Am i doing something wrong or thats the way it is? How to encode (read) ecu without loosing all the changes you have done? Thanks
Sponsor

Start ECU Repairing, ECU Cloning, and Chip Tuning today, all from an incredible price of just USD 385.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page