BEEMERS
  •  BEEMERS
  • 56.2% (Neutral)
  • Newbie Topic Starter
2017-04-08T08:37:36Z
I replaced msd 85 engine ecu on e70 5.0l x5 with boot mode. All good, start the car, test drive, fit all covers back. Ready for customer to take and when starting again it wanted to start but faild. stores code 2e77 igniton supply voltage. No spark, coils earth is ok voltage supply ok ecu does not puls coils. cheked ecu for soldering mistakes (none). No pinched wires. Annyone who can give good news.
Sponsor

Want to repair your Ecu?

Visit Hexprog page

BMWZG
  •  BMWZG
  • 100% (Exalted)
  • Advanced Member
2017-04-08T08:44:06Z
Probably a damaged ( short) driver for some ignition coil.
BEEMERS
  •  BEEMERS
  • 56.2% (Neutral)
  • Newbie Topic Starter
2017-04-09T08:36:16Z
Going to replace MSD85.1 ecu again, but can read old ecu . can I read/write isn without boot mode.
Autohex_II_BMW
2017-04-10T23:37:24Z
You can read by obd
If writing is needed then you need boot mode
BEEMERS
  •  BEEMERS
  • 56.2% (Neutral)
  • Newbie Topic Starter
2018-01-13T10:31:57Z
Please forgive me. I felt so ashamed 9 months ago about my msd85.1 no spark problem. I couldn't tell you. After fitting back the engine covers and harness, i accidentally fitted the coil plug connector on dme the wrong way around. It slides in deep enough to think it is in, but it doesn't clip. I probably plug and unplug that one 7 times and 3 months later only found my problem.
So match for being a bmw technician!
Users browsing this topic