JBE coding? · Microtronik Autohex II and Hexprog forum

Welcome Guest! To enable all features please Login or Register.

iamfooser
66.2% (Friendly)
Member Topic Starter

2017-10-16T14:07:01Z

Hi,

I am working on a E90. I could diagnose the car with autohex with original JBE but autohex detect 4v. So I swap it with another car, autohex detect 12v but I couldn't diagnose the car. Fail to get VO. Any advise please.

Sponsor

Start ECU Repairing, ECU Cloning, and Chip Tuning today, all from an incredible price of just USD 385.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page

Wanna join the discussion?! Login to your Microtronik Autohex II and Hexprog forum forum account or Register a new forum account

cardiagcom
100% (Exalted)
Advanced Member

2017-10-16T19:26:29Z

Please make coding JBE ,after coding the JBE show you correct VIN number then make coding again job done .After try diagnose the car .

Autohex_II_BMW
100% (Exalted)
Advanced Member

2017-10-17T06:23:07Z

hi,
If you are getting "failed to get VO" in coding/programming then there is chance of some error with the JBE. its not sending any signal to CAS.

LUIS ALESSO
59.8% (Neutral)
Newbie

2017-10-18T13:42:09Z

I have the same issue and i have to replace the JBE because program error

I think is an issue of autohex jbe coding