JBE coding? · Microtronik Autohex II and Hexprog forum

Welcome Guest! To enable all features please Login or Register.

iamfooser
66.2% (Friendly)
Member Topic Starter

2017-10-16T14:07:01Z

Hi,

I am working on a E90. I could diagnose the car with autohex with original JBE but autohex detect 4v. So I swap it with another car, autohex detect 12v but I couldn't diagnose the car. Fail to get VO. Any advise please.

Sponsor

Start Ecu Tuning today with Hexprog II Basic Set, all from an incredible price: ONLY USD 575.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page

cardiagcom
100% (Exalted)
Advanced Member

2017-10-16T19:26:29Z

Please make coding JBE ,after coding the JBE show you correct VIN number then make coding again job done .After try diagnose the car .

Autohex_II_BMW
100% (Exalted)
Advanced Member

2017-10-17T06:23:07Z

hi,
If you are getting "failed to get VO" in coding/programming then there is chance of some error with the JBE. its not sending any signal to CAS.

LUIS ALESSO
59.8% (Neutral)
Newbie

2017-10-18T13:42:09Z

I have the same issue and i have to replace the JBE because program error

I think is an issue of autohex jbe coding