Hi,

I am trying to reset and program a 8HP egs on a F10. Autohex keeps flashing the module over and over again. It says "module flashing failed, retrying", then it will continue to erase flash, program flash and etc. and the message appear again. It just keep going on without stopping. I disconnected internet and autohex crashes for it to stop.

I proceed to program egs and encoding just to try. Indicator shows P, but gear not engaging. Car only have one fault code and that is flexray initialization fault. That is all.

Any advise please?

Regards,

Contact Microtronic .. tomorrow .. for TV ( today is a day of rest )

---

Initialize flexray in ISTA D and try do egs reset again.

Contacted support. And problem solved!! Thanks guys.

what was the case? maybe someone need in the future.....

so what is the problem so members can read here????? if we have problem same like u in the future

hi,
we doubt it was some flash issue from EGS because it was failing and retrying many times and customer forcefully closed software when this happened but we just waited until it finishes and at the end autohex reset EGS and all works perfect.