1. Microtronik Autohex II and Hexprog forum
  2. Autohex II BMW
  3. Autohex II Ecu Flashing/Coding
  4. E71 Problems In MSD85.1 and 85.3 Need change Power Class
erickdnt
  •  erickdnt
  • 91.4% (Exalted)
  • Advanced Member Topic Starter
2017-09-19T16:55:43Z
I would like to know if I have modules that are the same as hardware I could get it to work on different engine type, Ex E71 car engines have one that is S63 and has the N63 nomal among others I can change this being that this motors many times has the same configuration, so the power of the map changes.
Sponsor

Start ECU Repairing, ECU Cloning, and Chip Tuning today, all from an incredible price of just USD 385.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page

roxetteer
2017-09-19T17:09:45Z
What do you mean? N63 has MSD85 and S63 has MSD85.1. They are two totally different hardware boards.
Autohex_II_BMW
2017-09-20T05:32:16Z
you can check in Indiv programming list the status of DME ,if not compatible it will say "REPLACE".In that situation you can even try to flash it in expert mode and make it compatible.
erickdnt
  •  erickdnt
  • 91.4% (Exalted)
  • Advanced Member Topic Starter
2017-09-20T17:59:07Z
ok very thx but not work i inoput same module s63 work good thx
Similar Topics
Users browsing this topic
  1. Microtronik Autohex II and Hexprog forum
  2. Autohex II BMW
  3. Autohex II Ecu Flashing/Coding
  4. E71 Problems In MSD85.1 and 85.3 Need change Power Class