Hello everyone. I was attempting to install a used MSV80 DME. I read the ISN in bench mode from original, at the end it gave me the ISN, but said "DME is in programming mode and to continue individual programming and do flashing for this DME".
I then read the replacement DME ISN to write into CAS, but now I have two DME's stuck in programming mode.
I then go to vehicle and attempt to enter coding/programming but get an error message stating cannot get vehicle order. I could really use some help on this one. Any advice would be greatly appreciated.

if you got message 'cannot get vehicle order' its from CAS not from DME.Make sure you make ignition ON or wake up car when connected.if you read DME ISN from used one just write that to CAS.