1. Microtronik Autohex II and Hexprog forum
  2. Autohex II BMW
  3. Autohex II DME/DDE and CAS ISN
  4. BDC - clip problem
Carat11
  •  Carat11
  • 63.4% (Friendly)
  • Member Topic Starter
2018-03-15T17:54:52Z
Hi I have problem have more BDC, always the same problem, connect on bench, identification ok, when I put clip SO-8 have message:
Please make sure the So-8 is correct, then try again.

Connect is 100% ok, I resolder eeprom, iron connection etc....
Where is problem ?

 so-8.png You have insufficient rights to see the content.
Sponsor

Start ECU Repairing, ECU Cloning, and Chip Tuning today, all from an incredible price of just USD 575.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page

cardiagcom
2018-03-15T22:50:27Z
Try desolder eeprom and connect on table with clip( sproboj wylutowac pamiec i podlaczyc bezposrednio do klipa , przemierz jeszcze polaczenia padow do kabelkow moze jakis kabelek daje w kosc albo sam clip jest do bani)
Findlaybum
2018-03-16T05:32:32Z
It needs the pull up resistors that are on the board so won't work if you remove it ..
OFFICIAL FRIEND OF OFFICIAL AUTOHEX II PARTNER .. AND OFFICIAL FRIEND OF THE BOSS .:)
Carat11
  •  Carat11
  • 63.4% (Friendly)
  • Member Topic Starter
2018-03-16T08:46:24Z
Clip test wire to connect DB-25 all ok
Eeprom solder in board and desolder - that the same error.
cardiagcom
2018-03-16T20:51:29Z
Originally Posted by: Carat11 

Clip test wire to connect DB-25 all ok
Eeprom solder in board and desolder - that the same error.


Witch Windows system you use for Autohex??? , to many problem is with WIN10 , WIN7 64bit working fine , try write to support I think help you via Teamviewer , or maybe try enable EXPERT MODE in your AH

Autohex_II_BMW
2018-03-17T06:31:03Z
please contact with support they can help you on this.
Similar Topics
Users browsing this topic
  1. Microtronik Autohex II and Hexprog forum
  2. Autohex II BMW
  3. Autohex II DME/DDE and CAS ISN
  4. BDC - clip problem