Hi
I replaced EKPS and program the car on ISTA/P
After program HU/RAD failed No signal on display
Is possible fix this issue with autohex2?
If I tried program with auto hex message come up module will take long please contact microtronik if you need remove this restriction ???
Please help
Thanks
Regards
Richard

Hi
I replaced EKPS and program the car on ISTA/P
After program HU/RAD failed No signal on display
Is possible fix this issue with autohex2?
If I tried program with auto hex message come up module will take long please contact microtronik if you need remove this restriction ???
Please help
Thanks
Regards
Richard

AGAIN RESTRICTION LIKE READ ISN ???????WHY

RESTRICTION IS DONE
ADJUSTING IN SETTINGS BUT NOW ERROR FAILED TO DOWNLOAD DATA FROM SERVER REF: 8301
PLEASE ADVISE
THANKS
RICHARD

RESTRICTION IS DONE
ADJUSTING IN SETTINGS BUT NOW ERROR FAILED TO DOWNLOAD DATA FROM SERVER REF: 8301
PLEASE ADVISE
THANKS
RICHARD

Do you use genuine ICOM NEXT with MOST ??, After replace EKPS you try to coding or choice option module replacement? , usually if I change any module first I try to coding full car and after try to programing , Batterry support unit must be connected to car and voltage must be over 13v, Try again with ISTAP .Autohex is no good tool for HU/RAD.

I replaced EKPS and program the car on ISTA/P
YES I use genuine ICOM NEXT F10 DONT HAVE MOST
EKPS IS PROGRAM OKAY
BUT HU/RAD FAILED
THANKS
REGARDS
RICHARD

I replaced EKPS and program the car on ISTA/P
YES I use genuine ICOM NEXT F10 DONT HAVE MOST
EKPS IS PROGRAM OKAY
BUT HU/RAD FAILED
THANKS
REGARDS
RICHARD

AAA this is F10 , that somethink wrong with power Fxxx series need Batterry
support unit 100A 13,8v, voltage over 13v must be .

Yes because you not connect MOST , if you connect and run ISTA P , Ista advice you, you must connect MOST for Programming multimedia interfaces, dont worry borow MOST from somebody and try again with ISTA , ISTA will be advice you programming will be in recovery mode .




F SERIES DONT HAVE MOST CONNECTION ! ! ! !
E SERIES HAVE MOST
ISTA/P ADVISE TO REPLACED HU/RAD NO RECOVERY MODE
I WILL RECOVERED WITH E-SYS THE BEST SW. NEVER LET ME DOWN AND ALWAYS RECOVERY EVERYTHING
THANKS
RICHARD

Yes F series
and i know need battery support with out you cant program the car
ISTA/P wont let you if you using Ori ICOM
You can using SW for imag power suplay bot that not my cop off coffee
I have genuine battery power support
Thanks

If you got HW4 you can program it.if got 8301 error try again its big file so need some time for downloading and good internet connection.

Hi
I tried 2 or 3 times same error
I think the connection is good I tried different internet
Can the Autohex fix this issue?
Or is wasting time?
Thanks
Richard

Yes I have HW4

please send teamviewer to support via skype

Hi
Can you send me Skype name please thanks