Hi, I seem to have a problem with a DME 81.2 ECU From a 2011 model 3 series that I have tried to read the ISN/SK from. I had it connected up on the bench with a cas unit and a working key and tried to read the ISN/SK
Autohex software reflashed the ecu but failed at 96% Also message box says Please program the module with latest update first, but when I go into programming and try to programme the ecu, the autohex software tell me the ECU is not ready for programming, If i look at module programming report i can see under status No program in flash
I have attached a picture of the programming software page, sorry it not a good clear picture
How do I repair this problem please
I sent this problem to Tech Support yesterday but have not had a reply, Not good support
Regards
IMG_1141.JPG
You have insufficient rights to see the content.
Edited by user
2016-06-14T20:13:48Z
|
Reason: forgot picture