Hello,
i have this car:
BMW X5 E70 2009-06 / 3.0d with automatic
1. I reset a used key
2. For a test, I have the key at the table to another CAS trained and key works
3. the learning in the vehicle takes place without error message
4. but the vehicle does not start
5. I read the EEprom with another tool
6. when opening with Hexprog the following status is displayed -> Programming Mode
7. the same with BMW Explorer ( Attention! Block mode- PROGRAMM Mode Change to DIAGNOSTIC MODE? )
Can this be the cause?
CAS_(9237046)_EEPROM_21.06.2019 12.44.48(New).rar You have insufficient rights to see the content.