As promised I would keep everyone updated. I sent the DME's back to andy and he modified the area of one of the DMEs at memory offset 00001130 thru 00001150. I have pictures of the modification.
After they arrived back to me I install everything back in the car he marked the DME master and slave so I installed Master on the right side and turn on to verify there are indeed 0 immo faults. CAS has no errors, DME1 no error codes, DME2 no more errors EGS no errors.
However now the engine will only spin by starter but it will not run. After cranking for a while It kicked a couple times like it was trying to start but then goes back to just spinning but not starting up..
I coded DME's again in ISTA, I cleared all adaptations, I double checked all the wiring and connectors but no luck.
Before I removed the DME's to ship them the engine would start and run but of course only on bank one cyl1-6.
I feel like I am one step closer.
Any suggestions or help will be of course greatly appreciated! I must get this car running soon.
Thank you my friends, and Thank you GYR! Your suggestion resolved the error code.