This is strange, so I cloned an MEVD17.2 successful, car starts and runs good, but when I'm trying to connect to the car via ethernet or icom using ISTA+ or E-SYS, I cannot.
ISTA+ comes with with an error that VIN cannot be read. After disconnecting the battery for 10 min or so I manage to connect to the car using e-sys and flashed the DME, flashing is going good but fails to update the VCM. Looking at the logs I notice this:
***** Link: VIN_MASTER_ETHERNET, Service: RDBI_PLAIN - ReadDataByIdentifier with unlimited Data-ID (plain hex value)
Request Parameter count: 2
- RDBI: 0x22
- RDBI_PLAIN_DID: 0xf190
Request PDU: (3) 22 f1 90
Result error: MCDError Severity: 2051, Error Code: 58640, Description: resource not available, Vendor Code: 2008, Vendor Description: T2 timeout occured
[WARN] [] com.bmw.esys.commons.exception.EsysExceptionHandler: PSdZ Error -- Reading VIN from master failed. [C058]
[INFO] [] com.bmw.psdz.jobs.uds.MCD3_ReadVIN: sjob READ_VIN/MCD3_ReadVIN finished with P2/T2-TIMEOUT-Error! Final diagnostic block in case of failure will be skipped! [AWT-EventQueue-0]
[INFO] [] com.bmw.psdz.jobs.uds.MCD3_ReadVIN: sjob READ_VIN/MCD3_ReadVIN finished Result: [Response 0: [ERROR_CODE: TIMEOUT P2/T2 occurred], [ERROR_DESC: T2 timeout on Service RDBI_PLAIN has error in result: [Severity=2051][ErrorCode=58640][ErrorCodeDescription=resource not available][VendorCode=2008][VendorCodeDescription=T2 timeout occured]; LinkName: VIN_MASTER_ETHERNET], [ERROR_SEVERITY: ERROR]] [AWT-EventQueue-0]
[INFO] [] com.bmw.prodias.collections.mcd.AbstractNamedCollection: provided name TP_CONTROL doesn't map to an item [AWT-EventQueue-0]
That means cloning this DME doesn`t pass the checksum? Anyone experienced this so far?