1. Microtronik Autohex II and Hexprog forum
  2. Autohex II BMW
  3. Autohex II Ecu Flashing/Coding
  4. e90 coding/ programming
trangdo
  •  trangdo
  • 59% (Neutral)
  • Newbie Topic Starter
2016-11-18T05:03:53Z
I replaced steering column center switch with steering angle sensor and having trouble encoded it. Support team help me by teamviewer and it went smooth.Thank you support . I want others to know they can count on Autohex and their support .Thank again.
Sponsor

Start ECU Repairing, ECU Cloning, and Chip Tuning today, all from an incredible price of just USD 385.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page

Levanime
2016-11-18T05:34:17Z
nice!

could you describe whats the correct way to do it?

i.e. what was your mistake and what they did so we know it next time we need
Autohex_II_BMW
2016-11-19T15:27:51Z
The solution was a little tricky
No Ecu for coding or flashing after replacement, steering angle sensor adjustment was not completed successfully, so the trick was to encode the DSC first, then steering angle adjustment.
Cheers
trangdo
  •  trangdo
  • 59% (Neutral)
  • Newbie Topic Starter
2016-11-20T15:53:22Z
I think it is important check there is no fault in junction control module
Similar Topics
Users browsing this topic
  1. Microtronik Autohex II and Hexprog forum
  2. Autohex II BMW
  3. Autohex II Ecu Flashing/Coding
  4. e90 coding/ programming