F01_WHEN PROGRAMMING CGW_SLEEP ON BOOTLOADER_BIG PROBLEM ! · Microtronik Autohex II and Hexprog forum

Welcome Guest! To enable all features please Login or Register.

zoranmadzar
75.6% (Friendly)
Member Topic Starter

2021-04-01T19:48:39Z

Hi to all
Today i have big problem when programming CGW on F01.....VERY DIFFICULT SITUATION......go to sleep on bootloader....message:" ERROR HAS NO DESCRIPTION ,PLEASE CONTACT MICROTRONOC".......
After that i make contact with Support autohex....verry fast i recovery CGW modulle...following instructions autohex!!!

TURN OFF ENET PROTOCOL AND TRY AGAYN !!!

PRAISE SUPPORT FOR A QUICK AND ACCURATE SOLUTION

PUBLIC: THX AH !

Sponsor

Start ECU Repairing, ECU Cloning, and Chip Tuning today, all from an incredible price of just USD 385.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page

Wanna join the discussion?! Login to your Microtronik Autohex II and Hexprog forum forum account or Register a new forum account

BMWZG
100% (Exalted)
Advanced Member

2021-04-02T15:44:40Z

Mictrotronic support has never disappointed me either 😉

Autohex_II_BMW
100% (Exalted)
Advanced Member

2021-04-03T06:43:59Z

thanks for the feedback.