Hi,

You write there is 100ohm resistor between CAN low and CAN high for ECU on bench and some ECU must have 1000ohm for boot mode.
My question is how much Watts to have the resistors and how much they have tolerance? For example: 100ohm 0,25W 5% tolerance

Best regards,
Mati

Autohex II tricore cable has a terminal resistor (120 ohm) included, so you don't need to add any resistor.
For boot mode, Autohex wvci iii boot pin is connected to a resistor of value 1000 ohm, so you don't need any external resistor too.
Only for MSX8X you need to use resistors as described in the tricore boot mode software.
The resistors dose not need to be able to handle high power, 1/4 watts are more than enough, which means you can use any set of resistors.
5% or 10% tolerance are fine too.

good to know :)

i've ordered 100ohm resistors )) so i dont need them

Thank you very much for your quick and reliable answers. Everything is clear.
I tested and works great, good job Microtronic Team!

Regards,
Mati