FEM Flashing Error message on end-of Unlock · Microtronik Autohex II and Hexprog forum

Welcome Guest! To enable all features please Login or Register.

obdsystems
60.6% (Friendly)
Newbie Topic Starter

2022-06-21T20:05:52Z

Hi today went to F20 AKL

Believe my mistake was to try Invid coding of FEM on bench but anyway after error message went into unlock.
At end-of unlock came flashing error check for updates error.

Now no diagnostics and error on programming key.
So guess need to re-flash FEM - tech support tomorrow!

Sponsor

Start ECU Repairing, ECU Cloning, and Chip Tuning today, all from an incredible price of just USD 385.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page

Wanna join the discussion?! Login to your Microtronik Autohex II and Hexprog forum forum account or Register a new forum account

Autohex_II_BMW
100% (Exalted)
Advanced Member

2022-06-22T06:40:10Z

hello
you can do programming or coding on bench itself , you can check fem on bench from coding/programming-->indiv programming. Update both GW and BODY then proceed with unlock. If any doubts contact us our team.

obdsystems
60.6% (Friendly)
Newbie Topic Starter

2022-06-22T19:46:34Z

All ok went back next day and re-run fem update.

Not all instant results