E92: Swapped CAS3, now have 5f60 DSC fault · Microtronik Autohex II and Hexprog forum

Welcome Guest! To enable all features please Login or Register.

Bemermotorcars
52% (Neutral)
Newbie Topic Starter

2020-11-11T16:31:53Z

Hello,

I am working on a 2011 328i xdrive and I swapped CAS3 from a 2011 X5. I performed these steps:

- saved key file from original cas and loaded on donor cas
- restored FA from FRM to donor CAS
- changed VIN
- changed power class in Hexprog from "none" to "level 1" on donor CAS to match DME.

The car starts and everything, but I have a fault in the DSC "5f60: DSC control unit, incorrect part number (Active front steering)". When I plug in the original cas there is no fault. I've tried re-coding dsc, cas, and others but the fault does not go away. Does anyone have any ideas?

Thanks

Sponsor

Start ECU Repairing, ECU Cloning, and Chip Tuning today, all from an incredible price of just USD 385.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page

Wanna join the discussion?! Login to your Microtronik Autohex II and Hexprog forum forum account or Register a new forum account

Bemermotorcars
52% (Neutral)
Newbie Topic Starter

2020-11-11T18:02:44Z

Issue sorted out, for those reading in the future, I could have sworn I coded the donor CAS after loading the FA, but maybe I didn't. Anyways, in Indiv Coding for CAS under Advanced, I went to the coding parameters and noticed it still had coding parameters for the 2011 X5. So I re-coded the CAS again and this time all the parameters were for an e92. The fault went away.