•  hojo29
  • 56.8% (Neutral)
  • Newbie Topic Starter
I wanted to clone a BDC today and connected it according to the circuit diagram. The Autohex device got warm on the underside and the adapter cable got warm at the plug. Both smelled a bit scorched. I opened the Autohex device and component Z8 on the board layout was burned. I also opened the FEM/BDC adapter cable and here component D5 on the board layout is burned.
Ask for help from Autohex or a user from the forum what can be done here.
Because I need the device urgently.
Autohex device is still recognizable and I don't see any damage to the circuit board myself.

 20220907_195856.jpg You have insufficient rights to see the content.
 20220907_195924.jpg You have insufficient rights to see the content.

Start ECU Repairing, ECU Cloning, and Chip Tuning today, all from an incredible price of just USD 385.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page

please contact the support team, they will check with you and provide you solution.
thank you