singh336
  •  singh336
  • 61.2% (Friendly)
  • Newbie Topic Starter
2023-05-08T20:30:16Z
Hey everyone,

Have hextag here, trying to take a full flash and eprom read from an FRM 2 (one circuit for turn signal is dead and unable to reset short circuit, but otherwise module works and is online via OBD communication)

I'm selecting FRM 2 under hexprog and wiring is according to wiring diagrams via microtronik website. However everytime it will come back with error REF 943 - Failed to unlock chipset

Normally its a wiring problem, we've checked this many times and same problem here.


Any insight would be appreciated !
Sponsor

Start ECU Repairing, ECU Cloning, and Chip Tuning today, all from an incredible price of just USD 385.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page

Tommy.B
2023-05-27T10:51:34Z
I tried to get a read on a FRM2 also recently and it wouldnt do it on bench pin out .... i used VVDI prog to read abd write the info
Autohex_II_BMW
2023-05-29T12:01:19Z
please make sure other bdm modules like cas or frm 3 can be read with the device. if same please contact the support team to check the faults.