BmwMerc
  •  BmwMerc
  • 74.6% (Friendly)
  • Member Topic Starter
2023-05-11T21:13:27Z
Hi,

I think there are some issues with CAS3+ editor.
I`ve got a CAS eeprom file which was in boot mode after unsuccessful programming, but when I open in CAS3+ editor it shows Normal Mode in drop box. So, the first issue it wasn`t showing correct mode.
Still clicked on Normal Mode and then I tried to save the file to fix it, but nothing has changed in there.
Then I set to Programming Mode and saved file and then back to Normal Mode --> Saved and only then it FF FF FF the required eeprom area. Microtronik team, please check and fix it.
Also in recent weeks, months I had some strange issues with HexTag like FRM3 repair problems a few times, then remote key programming failures, etc. Something what never happened in the past. Just a reminder to HexTag support and developers that we still use other features of this tool not just tuning options. Thanks

P.S. One more difference noticed as HexProg software has two options for EDC16C35 for BMW cars and Hexprog Tuner only one on this type of ECU, but we all know there are two types MPC561 and MPC563. Please sort this one or give us a clear instructions if we should use EDC16CP35 MPC563 protocol instead. Please explain this. Thank you
Sponsor

Start ECU Repairing, ECU Cloning, and Chip Tuning today, all from an incredible price of just USD 385.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page