SIM271DE20 boot mode connection · Microtronik Autohex II and Hexprog forum

Welcome Guest! To enable all features please Login or Register.

Brucestafo
51.4% (Neutral)
Newbie Topic Starter

2023-05-30T20:37:35Z

Hello I am new to this cloning and I am not sure how to connect to this SIM271DE20 ecu. Can someone assist me?
Why is there a diagram for the Hexprog power module as well as the tricore cable?
Do I use both?
This ecu pins are to big for the power module cable

Boot.png You have insufficient rights to see the content.

Sponsor

Start ECU Repairing, ECU Cloning, and Chip Tuning today, all from an incredible price of just USD 385.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page

Wanna join the discussion?! Login to your Microtronik Autohex II and Hexprog forum forum account or Register a new forum account

Brucestafo
51.4% (Neutral)
Newbie Topic Starter

2023-05-30T21:02:49Z

I realised that what I though was a Tricore cable is actually the BDM cable and that Hexprog don't use the Tricore cable. Can I still clone this ecu with Hexprog power module and cables?

Autohex_II_BMW
100% (Exalted)
Advanced Member

2023-06-01T07:38:28Z

Please use the power module with supplied cables to read/write ecus, if you have difficulty soldering the boot and signal wires to pcb you can use the extended wires to connect to PCB.