ecarkey
  •  ecarkey
  • 53.4% (Neutral)
  • Newbie Topic Starter
2017-02-22T03:45:25Z
I tried to connect EGS to communicate with CAS & JBE. Failed to read it.
Even I tried to connect the PT-CAN-H & CAN-L with 120 Ohm like DME connection.
But I still could't read EGS, even I tried another one. Would it be a chance to read it by on bench?
May anyone support me with the correct EGS 6HP connection by on bench?

BTW, the connection is found in ISTA.
I still don't know what the wrong is.
Do I miss something?
Sponsor

Start ECU Repairing, ECU Cloning, and Chip Tuning today, all from an incredible price of just USD 385.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page

Autohex_II_BMW
2017-02-22T16:40:19Z
If your connection is good, all Ecus are working fine, you must be able to communicate.
If you are using version 1.0.41, you should not use ON BENCH as these functions will test only CAS and DME only ( and they must be connected directly without JBE).