1. Microtronik Autohex II and Hexprog forum
  2. Autohex II BMW
  3. Autohex II Ecu Flashing/Coding
  4. BMW F06 NBT update
gyany
  •  gyany
  • 52% (Neutral)
  • Newbie Topic Starter
2017-03-17T17:41:47Z
recently try to update a NBT unit in a 2013 F06, but the time allowed for the job was 203 hours !!! is anything wrong there? why is that ?
Sponsor

Start Ecu Tuning today with Hexprog II Basic Set, all from an incredible price: ONLY USD 575.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page

rbauto
2017-03-17T19:45:02Z
That module should be programmed using an icom and most connector. You are trying to program a few gb over obd. I believe transfer rate on obd is 16kb/s. I may be wrong.
gyany
  •  gyany
  • 52% (Neutral)
  • Newbie Topic Starter
2017-03-19T20:44:41Z
the Most Connector is used in programming of E series ( and that series have CIC ) . The ICOM is connected to OBD aswell !
rbauto
2017-03-20T03:47:53Z
You're correct. My apologies.
Gbyleveldt
2017-03-20T13:51:51Z
F Series is Ethernet for programming. The Autohex dongle doesn't support Ethernet. The Icom does, hence it goes faster programming NBT using Icom rather than Autohex tool
roxetteer
2017-03-20T17:21:54Z
Originally Posted by: Gbyleveldt 

F Series is Ethernet for programming. The Autohex dongle doesn't support Ethernet. The Icom does, hence it goes faster programming NBT using Icom rather than Autohex tool



Autohex supports ethernet. That's why it can update a F series car which has a mixed network of MOST and Ethenet. Otherwise it wouldn't work.
Gbyleveldt
2017-03-21T12:04:45Z
Yes, Autohex Software supports Ethernet. It's the DONGLE that doesn't.
Similar Topics
Users browsing this topic
  1. Microtronik Autohex II and Hexprog forum
  2. Autohex II BMW
  3. Autohex II Ecu Flashing/Coding
  4. BMW F06 NBT update