Kumistheru
2018-08-08T04:49:09Z
I am looking for connect MSD80 ecu to read ISN on bench. I have only access to the ecu and not the car. So, I can't read OBD.
I have tried reading on bootmode but it ask for password which I don't have.
Sponsor

Want to repair your Ecu?

Visit Hexprog page

Autohex_II_BMW
2018-08-08T05:52:07Z
hi,
please check with the attached photo,use our isn boot mode cable and go to ON bench option in autohex software for reading ISN and password.
 HW4 MSD80.png You have insufficient rights to see the content.
Kumistheru
2018-08-08T07:27:20Z
Thank you. Please check whether the cable as per the picture. What I have does have extra color wires such as yellow which is not shown in your photo.
Please confirm.

 20180808_172046.jpg You have insufficient rights to see the content.
Kumistheru
2018-08-08T08:42:21Z
Hi, I have managed to connect it to ecu. Ecu did flash and then I have following message. I can't do anything after that.

Please advice.

 isn-read_msd80.JPG You have insufficient rights to see the content.
Kumistheru
2018-08-08T08:53:39Z
When I select ISN read again, now autohex says the following message.
 isn-read_msd80_1.JPG You have insufficient rights to see the content.
Autohex_II_BMW
2018-08-08T11:53:05Z
please program dme from indiv programming,this dme is in programming mode now.also please contact support in skype for technical doubts for a faster response.
Best regards