have here on the bench a MSD81.2 from a E88.
now i'm trying to read the ISN from it but keep getting "can not communicate with ecu, check wireing and power supply".
have connect 13Volt 5A as power supply and wire connected as diagram from autohex.
22 yellow can high
44 orange can low
16 black Gnd (smal connector ecu)
2x red on pin 1big, 1smal (smal connector ecu).

can i get some help?

have here on the bench a MSD81.2 from a E88.
now i'm trying to read the ISN from it but keep getting "can not communicate with ecu, check wireing and power supply".
have connect 13Volt 5A as power supply and wire connected as diagram from autohex.
22 yellow can high
44 orange can low
16 black Gnd (smal connector ecu)
2x red on pin 1big, 1smal (smal connector ecu).

can i get some help?

hi,
please use power supply 12V 2A also click on update of software then click configuration and try again,if still facing issue contact support on skype/whatsapp.

have here on the bench a MSD81.2 from a E88.
now i'm trying to read the ISN from it but keep getting "can not communicate with ecu, check wireing and power supply".
have connect 13Volt 5A as power supply and wire connected as diagram from autohex.
22 yellow can high
44 orange can low
16 black Gnd (smal connector ecu)
2x red on pin 1big, 1smal (smal connector ecu).

can i get some help?

hi,
please use power supply 12V 2A also click on update of software then click configuration and try again,if still facing issue contact support on skype/whatsapp.

Update: after update AH can read ecu without problem.
thank you