manual coding · Microtronik Autohex II and Hexprog forum

Welcome Guest! To enable all features please Login or Register.

sdzeeshanali15
53.2% (Neutral)
Newbie Topic Starter

2018-02-18T05:01:24Z

hiii is it possible to deactivate the dyanamic damping control message in f series F02 by manual coding ,i tried but unsuccesful plszz help.

Sponsor

Start ECU Repairing, ECU Cloning, and Chip Tuning today, all from an incredible price of just USD 385.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page

Wanna join the discussion?! Login to your Microtronik Autohex II and Hexprog forum forum account or Register a new forum account

Tibibond
100% (Exalted)
Advanced Member

2018-02-18T11:45:13Z

I believe that you must manual code icm-vdm and then vo code kombi, icm-ql, and all other modules. Icm-vdm will not vo code because hw is diffent between edc car and no edc.

julienjj
55.2% (Neutral)
Newbie

2018-02-19T01:39:31Z

Have you removed the control unit from the trunk ? As long as the EDC is plugged in it will trigger the malfunctions codes.
I removed it on a tons of car to install coilovers without any fuss.
Remove the SALAPA code from VO, then re-code Kombi, DSC, Idrive and FRM