I need assistance with unlocking this fem. I went to unlock it and it informed me the ecu needs updating. I first went to coding and updated the fem body there it seemed to do the encoding process fine. i went back to unlock the fem but still said ecu needs updating. Then i went into programming and there were 2 available updates. The first was fem gw and the second was fem body. It said it updated fem gw then I went to fem body but after a few seconds it gives an error. "module rejecting to switch to required mode reference 830c" I am wondering if me going to coding first caused this problem or am I doing something wrong? Anyway to correct this issue? Thanks
IMG_0621.jpg You have insufficient rights to see the content. IMG_0622.jpg You have insufficient rights to see the content. IMG_0623.jpg You have insufficient rights to see the content. IMG_0624.jpg You have insufficient rights to see the content. IMG_0625.jpg You have insufficient rights to see the content. IMG_0626.jpg You have insufficient rights to see the content. IMG_0627.jpg You have insufficient rights to see the content. IMG_0628.jpg You have insufficient rights to see the content. IMG_0629.jpg You have insufficient rights to see the content. IMG_0630.jpg You have insufficient rights to see the content.