1. Microtronik Autohex II and Hexprog forum
  2. HexProg Programming Tool
  3. HexProg Intro
  4. Problem with reading ecu Bosch EDC17CP45 factory mode
Bartas222
2021-04-23T12:24:12Z
Hey, I have a problem with reading the ECU EDC17CP45 in factory mode.
This mode worked because I already read the same ECU in this way. I am asking for some help. Since boot mode reading is very difficult in this ecu processed-5.jpg.jpeg You have insufficient rights to see the content. processed-4.jpg.jpeg You have insufficient rights to see the content.
Sponsor

Start ECU Repairing, ECU Cloning, and Chip Tuning today, all from an incredible price of just USD 385.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page

BMWZG
  •  BMWZG
  • 100% (Exalted)
  • Advanced Member
2021-04-23T14:09:13Z
I had some problems with wirings from Power module to ECU and exactly conectors in Power Module. Check this and all will work. The power module is a good solution, but unfortunately it has poor cable connectors.
Autohex_II_BMW
2021-04-24T06:01:20Z
Originally Posted by: Bartas222 

Hey, I have a problem with reading the ECU EDC17CP45 in factory mode.
This mode worked because I already read the same ECU in this way. I am asking for some help. Since boot mode reading is very difficult in this ecu processed-5.jpg.jpeg You have insufficient rights to see the content. processed-4.jpg.jpeg You have insufficient rights to see the content.



we hope its working now.
Bartas222
2021-04-25T10:34:27Z
This is how the problem works was exactly as the colleague described above.
Similar Topics
Users browsing this topic
  1. Microtronik Autohex II and Hexprog forum
  2. HexProg Programming Tool
  3. HexProg Intro
  4. Problem with reading ecu Bosch EDC17CP45 factory mode