i tried to clone a SID211 Ford ECU, i used the clone function

but afterwards i read EEPROM & Flash and the Flash was almost same (few bytes difference) but there was quite a few differences in Eeprom,

i used adjustable Power Supply with 14.5v but it showed on hexprog sw as 14v input, the instructions do say 14.5 minimum but i don’t want to up my power supply to 15v incase i damage the hexprog

also what is the difference between using the ecu clone function and just writing the eeprom and flash separately? also what extra data does the ecu clone function copy over!


Start ECU Repairing, ECU Cloning, and Chip Tuning today, all from an incredible price of just USD 385.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page

in short if you power ecu on /off on bench it will write errors to eeprom what is normal
Users browsing this topic