Him
i tried to clone a SID211 Ford ECU, i used the clone function
but afterwards i read EEPROM & Flash and the Flash was almost same (few bytes difference) but there was quite a few differences in Eeprom,
i used adjustable Power Supply with 14.5v but it showed on hexprog sw as 14v input, the instructions do say 14.5 minimum but i don’t want to up my power supply to 15v incase i damage the hexprog
also what is the difference between using the ecu clone function and just writing the eeprom and flash separately? also what extra data does the ecu clone function copy over!
cheers