manual coding · Microtronik Autohex II and Hexprog forum

Welcome Guest! To enable all features please Login or Register.

sdzeeshanali15
53.2% (Neutral)
Newbie Topic Starter

2018-02-18T05:01:24Z

hiii is it possible to deactivate the dyanamic damping control message in f series F02 by manual coding ,i tried but unsuccesful plszz help.

Sponsor

Start Ecu Tuning today with Hexprog II Basic Set, all from an incredible price: ONLY USD 575.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page

Tibibond
100% (Exalted)
Advanced Member

2018-02-18T11:45:13Z

I believe that you must manual code icm-vdm and then vo code kombi, icm-ql, and all other modules. Icm-vdm will not vo code because hw is diffent between edc car and no edc.

julienjj
55.8% (Neutral)
Newbie

2018-02-19T01:39:31Z

Have you removed the control unit from the trunk ? As long as the EDC is plugged in it will trigger the malfunctions codes.
I removed it on a tons of car to install coilovers without any fuss.
Remove the SALAPA code from VO, then re-code Kombi, DSC, Idrive and FRM