1. Microtronik Autohex II and Hexprog forum
  2. HexProg Programming Tool
  3. HexProg Intro
  4. Me7.5 Read error
Sasika
  •  Sasika
  • 56.8% (Neutral)
  • Newbie Topic Starter
2020-09-28T22:09:26Z
Hi,
I tried read 2 me7.5 ecus but I always got an error message on both ECU.
I use the power module.
Can you help me what's wrong?
Thank you in advance.
 IMG_20200928_210758__01.jpg You have insufficient rights to see the content.
 IMG_20200928_210613__01.jpg You have insufficient rights to see the content.
 IMG_20200928_210412.jpg You have insufficient rights to see the content.
Sponsor

Start ECU Repairing, ECU Cloning, and Chip Tuning today, all from an incredible price of just USD 385.00.

No annual fees, no extra charges: You pay only when you have a job.

Visit Hexprog II page

Autohex_II_BMW
2020-09-29T06:08:34Z
please use 12v 2a ac/dc power supply for reading ecus in hextag, this error means no communication with ecu, please try with recommended power supply and try again
Sasika
  •  Sasika
  • 56.8% (Neutral)
  • Newbie Topic Starter
2020-09-29T07:37:06Z
I use 12v 3A power supply.
When I push the backup I got different error than I try read pflash, eeprom...etc.

 IMG_20200929_083007__01.jpg You have insufficient rights to see the content.
Sasika
  •  Sasika
  • 56.8% (Neutral)
  • Newbie Topic Starter
2020-09-29T07:40:28Z
Ok I found it.
Have to choose an other me7.5 which is different board.
Works fine.
Thank you
Similar Topics
Users browsing this topic
  1. Microtronik Autohex II and Hexprog forum
  2. HexProg Programming Tool
  3. HexProg Intro
  4. Me7.5 Read error