Replaced faulty DME with stalling issue with a second hand unit from a f30 316 316i. . Cleared faults and adaptations. Car starts no problem.
Engine has loss of power.

FC 2fa4 incorrect data record
.

Programmed DME latest level.
Same issue. Re-installed original DME, Cleared faults and adaptations. No faults, engine runs fine.
Programmed original DME to latest level, same software version as donor DME. Still no issues. Reinstalled donor DME and wrote ISN again, same fault as before, and loss of power. How to correct?

NOTE: both same dme 316 too

Reset working hours to ZERO, then code the DME. problem will be solved.

how to reset working hours to zero ????????????

You can reset working hours by Autohex II ISN boot mode software.

sir i sent you many email today but no reply
and i am new user not expert to use it
i know i asked many but to know how to use
and you didnt write any instruction and error code resolve by pdf or other ways
please i am stuck and you didnt feel that
thanks

Yesterday I myself spent with you more than 1 hour on team viewer. explained to you step by step what you should do, and fixed your problem in CAS.
Last week I did my best to explain to you that installing Autohex II problem is coming from your laptop, You did not believe me until the second time on teamviewer.
You are not bothering yourself to just discover what functions are available, you don't read the information from Autohex (Ecu in programming mode, or No program in flash status).
Try to figure out your problem other than waiting us to do the job on behalf of you.
We will respond ONLY if we believe there is a problem from our side. Please keep in mind, technical support is to support, NOT to DO ON BEHALF.

yes you are right
but i reset working our to zero like you said
after that dme cant complete coding and and vin number unknown and i sent you emaiil but you didnt reply
sir i bought autohex and i like it but i have something wrong

Interesting, what was wrong with CAS?

and I've searched for info about editing working hours but could not find,
http://www.microtronik.c...ing-bmw-ecu-individually 
or some other page?

Thanks

" Autohex II ISN boot mode software"..................DME working hours .:)

 working hours.PNG You have insufficient rights to see the content.

---

im dme
but after reset it to zero
coding not completed
and vin set to unknown numberrs
car cant start and fault in dme short circut to ground ( ignition, injectors )

dme short circut to ground ( ignition, injectors )

The end of ECU . ECU is dead.

Send by email to support the Ecu part number, and Ecu Model (MEX17XX...), you can reach these info from programming list.

sent

sent

any news ?

So, closing this thread, Here is the results
We find that no issue in coding the ecu from Autohex part, we asked the customer for teamviewer to make investigate about his issue.
We find out the dme is REJECTING to enter the coding mode (ecu coding session), the ecu has corrupted vin, there is a software problem.